Contact a qualified installer to install Solarium®. Before installation read and follow the instructions attached to the invoice.

Hints:

• Use a diamond disk ventilated tile to cut Solarium®;
• In outdoors áreas, all gardens and top soil usage must be already finished prior to Solarium® installation;
• Keep the installation area clean;
• The sub floor must be well leveled and cleaned before installation;
• Immediately before installation dump wet the sub floor and clean the back of each tile with a wet brush;
• Use mortar type AC III both on the sub floor and back of each tile (back butter);
• Slightly press each tile with finger and use a rubber hammer protected with duct tape;
• Minimum grout must be 4 mm and grouting must be done only after 72 hours of Solarium® is installed;
• Attention! Before grouting protect Solarium® tiles edges with adhesive tape. Apply the grout and remove the tape after 30 minutes of the grouting being
  completed;
• Do not grout during intensive hot days;
• Solarium must be the last product installed on the job site;
• Avoid traffic 3 days after the installation.